Comparing Radiant and Baseboard Heaters



 


Lots of people looking for electronic heating units are often unaware there are two main kinds of electrical heating elements: convection and radiant. A type of convection heater is the normally observed baseboard heater in houses designed to use some older forms of electric powered heating systems. A fine example of a good radiant heating unit might be a space heater.

Convective Heating Units
Any time heated air ‘convects’ this means it goes up in the environment. Convection heating units make use of this exact same method. The environment is heated whenever it comes into contact with any of the narrow heater discs. The heated air pulls in cold fresh air to take its place as it floats up. This method creates a good air movement in the space that’s continually becoming increased with hot air.

Because warmed air circulates in to the bedroom, the areas temperature is raised. A thermostat will see the increase in warmth and then shut off the unit once the area heating rises the specified degree. A thermostat ensures that the heater will start once again in case the room temperature declines too far.

Convection electric heater units range from upright, thin tower styles down to little, squat box designs. Manufacturers of modern heating units have tried to enhance this process by using ceramic and oil to enhance the heater units thermal mass. Some modern heating elements will oscillate them selves to improve air flow across its surface.

Radiant Heater Units
Radiant heating elements have been around for a long time. You may have even burnt your own self on the outdated propane space heating units which were known for safety problems. Even the classic electrical power models had numerous issues with safety. The issues have largely been erased in modern spot heating elements. The benefit of the radiant heating unit is generally that it can concentrate its heat power at a specific target. The target getting warmed from this kind of heater unit experiences much more heating than they would by using a non-directional heating unit for an identical level of power input.

 

Comments are closed.